Removing A Gpu - Dell EMC PowerEdge R750 Installation And Service Manual

Removing a GPU

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If applicable, disconnect the cables from the expansion card.
4. Remove the GPU air shroud top
5. Remove the GPU air shroud
6. Remove the full length expansion card
Steps
1. To remove the GPU from Riser 1:
a. Disconnect the GPU power cable from the GPU card.
b. Open the expansion card holder latch on the riser.
c. Press the tab, and pull the card holder from the riser.
d. Hold the GPU card by the edges and pull the card from the riser.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 159. Removing GPU from Riser 1
2. To remove the GPU from Riser 4:
a. Slide the expansion card latch on the riser.
b. Disconnect the GPU power cable from the GPU card.
c. Press the tab, and pull the card holder from the riser.
d. Open the expansion card holder latch on the riser.
e. Hold the GPU card by the edges and pull the card from the riser.
162 Installing and removing system components
Safety instructions.
Before working inside your
cover.
filler.
riser.
system.