Optional Vga Port For Liquid Cooling Module; Removing The Vga Port - Dell EMC PowerEdge R750 Installation And Service Manual

Optional VGA port for liquid cooling module

Removing the VGA port

The procedure to remove VGA port from Riser 3 or 4 is same.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud
NOTE: VGA port is supported only in slot 4 or slot 8 of the expansion card riser.
Steps
1. Loosen the captive screws on the system.
2. Press the blue release tab or blue button on the riser and holding the edges lift the expansion card riser from the riser
connector on the system board.
3. Disconnect the VGA port cable from the liquid cooling (LC) rear I/O board.
Figure 173. Disconnecting the VGA port cable
4. Open the latch on the expansion card riser and slide the VGA port out of the expansion card riser.
Safety instructions.
Before working inside your
or remove the GPU air shroud.
system.
Installing and removing system components 173