Right Control Panel View - Dell EMC PowerEdge R750 Installation And Service Manual

Table 3. Left control panel with optional iDRAC Quick Sync 2 indicator (continued)
Item Indicator, button, or
connector
2 System health and system
ID indicator
3 iDRAC Quick Sync
2 wireless indicator
(optional)
NOTE: For more information about the indicator codes, see the

Right control panel view

Figure 7. Right control panel view
Table 4. Right control panel
Ite Indicator or button
m
1 Power button
2 USB 2.0-compliant port
3 iDRAC Direct port
(Micro-AB USB)
4 VGA port
12 System overview
Icon
Icon Description
Indicates if the system is powered on or off. Press the power button to
manually power on or off the system.
NOTE:
compliant operating system.
The USB port is a 4-pin connector and 2.0-compliant. This port enables
you to connect USB devices to the system.
The iDRAC Direct port (Micro-AB USB) enables you to access the iDRAC
Direct Micro-AB features. For more information, see the iDRAC User's
Guide available at
NOTE:
(type AB) cable, which you can connect to your laptop or tablet. Cable
length should not exceed 3 feet (0.91 meters). Performance could be
affected by cable quality.
Enables you to connect a display device to the system.
Description
Indicates the system health. For more information, see the
System health and system ID indicator codes
Indicates if the iDRAC Quick Sync 2 wireless option is
activated. The Quick Sync 2 feature allows management of the
system using mobile devices. This feature aggregates hardware/
firmware inventory and various system level diagnostic/error
information that can be used in troubleshooting the system. You
can access system inventory, Dell Lifecycle Controller logs or
system logs, system health status, and also configure iDRAC,
BIOS, and networking parameters. You can also launch the virtual
Keyboard, Video, and Mouse (KVM) viewer and virtual Kernel-
based Virtual Machine (KVM), on a supported mobile device.
For more information, see the Integrated Dell Remote Access
Controller User's Guide at www.dell.com/poweredgemanuals.
System diagnostics and indicator codes
Press the power button to gracefully shut down the ACPI-
https://www.dell.com/idracmanuals
You can configure iDRAC Direct by using a USB to micro USB
section.
section.
.