Optional Internal Usb Card; Removing The Internal Usb Card; Installing The Internal Usb Card - Dell EMC PowerEdge R750 Installation And Service Manual

b. Enter the correct time and date in the System Setup Time and Date fields.
c. Exit the System Setup.
d. To test the newly installed battery, remove the system from the enclosure for at least an hour.
e. Reinstall the system into the enclosure after an hour.
f. Enter the System Setup and if the time and date are still incorrect, see

Optional internal USB card

Removing the internal USB card

Prerequisites
CAUTION: To avoid interference with other components in the server, the maximum permissible dimensions of
the USB memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the expansion card
Steps
1. Holding the blue tag, lift the internal USB card to disconnect from the connector on the system board.
2. Remove the USB memory key from the internal USB card.
Figure 195. Removing the internal USB card
Next steps
1. Replace the internal USB

Installing the internal USB card

Prerequisites
1. Follow the safety guidelines listed in the
Safety instructions.
Before working inside your
risers.
card.
Safety instructions.
Getting help
system.
Installing and removing system components
section.
189