Perc Module; Removing The Rear Mounting Front Perc Module - Dell EMC PowerEdge R750 Installation And Service Manual

6. Remove the cooling fan cage
NOTE: To avoid damaging the backplane, ensure to move the control panel cables from the cable routing clips before
removing the backplane.
NOTE: Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align the slots on the drive backplane with the guides on the system.
2. Slide the drive backplane into the guides and lower the backplane until the blue release tabs clicks into place.
3. Route the cables properly through the cable guide.
Figure 95. Installing the drive backplane
Next steps
1. Connect the drive backplane cables to the connector on the system board and backplane.
2. Install the cooling fan cage
3. Install the drives.
4. If removed, install the air shroud
5. Install the drive backplane
6. Follow the procedure listed in

PERC module

This is a service technician replaceable part only.

Removing the rear mounting front PERC module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the drive backplane
92 Installing and removing system components
assembly.
assembly.
or install the GPU air
cover.
After working inside your
Safety instructions.
Before working inside your
cover.
shroud.
system.
system.