Gpu Kit - Dell EMC PowerEdge R750 Installation And Service Manual

GPU kit

The GPU FL and HL kits are available for the Customer. Depending on the kit ordered, the respective components are available.
CAUTION: Do not install GPUs, network cards, or other PCIe devices on your system that are not validated
and tested by Dell. Damage caused by unauthorized and invalidated hardware installation will null and void the
system warranty.
WARNING: Consumer-Grade GPU should not be installed or used in the Enterprise Server products.
Table 69. Components in the full length (FL) GPU kit
Components
Risers
Shroud
Fans
Heat sinks
Cables
Foam
FL - Full Length, HL - Half Length, HPR - High Performance, SLVR - Silver
#
NOTE: The Riser R3B is shipped with the GPU FL kit, however riser R3B does not support GPU.
NOTE: ¹ The configuration 3-1 supports GPU only on slots 2 and 7.
Table 70. Components in the half length (HL) GPU kit
Components
Risers
Shroud
Fans
Heat sinks
Cables
Foam
HL - Half Length, HPR - High Performance, SLVR - Silver
NOTE: * Refer to expansion card installation guidelines
system.
Before you begin, follow the
216 Upgrade Kits
GPU FL GOLD kit
Details
Riser configuration 2-1,
3-1¹, or 4-1
GPU shroud
GOLD HPR
T-type heat sink
for processor 1 and
processor 2
Power cable
Mylar foam
GPU HL GOLD kit
Details
Riser configuration 2-2
or 4-2
GPU shroud
GOLD HPR
T-type heat sink
for processor 1 and
processor 2
N/A
Mylar foam
safefy guidelines and before working inside the system
Quantity
3 x FL risers (R1A or
R1C, R4A) + 3 x HL
risers (R2A, R3A, or
#
R3B )
1
6
2
2x (6+2)-pin power
cables, 2 x 8-pin power
cables
1
Quantity
8 x HL risers (R1A or
R1C, R2A, R3A, or R3B,
R4A)
1
6
2
0
1
for more information on riser configuration supported for the
GPU FL SLVR kit
Details
Riser configuration 2-1,
3-1¹, or 4-1
GPU shroud
SLVR HPR
T-type heat sink
for processor 1 and
processor 2
Power cable
Mylar foam
GPU HL SLVR kit
Details
Riser configuration 2-2
or 4-2
GPU shroud
SLVR HPR
T-type heat sink
for processor 1 and
processor 2
N/A
Mylar foam
instructions.
Quantity
3 x FL risers (R1A or
R1C, R4A) + 3x HL
risers (R2A, R3A, or
#
R3B )
1
6
2
2x (6+2)-pin power
cables, 2 x 8-pin power
cables
1
Quantity
8 x HL risers (R1A or
R1C, R2A, R3A, or R3B,
R4A)
1
6
2
0
1