Intrusion Switch Module; Removing The Intrusion Switch Module - Dell EMC PowerEdge R750 Installation And Service Manual

2. Follow the procedure listed in
3. Remove the expansion card
Steps
1. Connect the USB key to the internal USB card.
NOTE: For information on the exact location of USB on system board, see
section
2. Align the internal USB card with the connector on the system board and press firmly until the internal USB card is seated.
Figure 196. Installing the internal USB card
Next steps
1. Install the expansion card
2. Follow the procedure listed in
3. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.

Intrusion switch module

This is a service technician replaceable part only.

Removing the intrusion switch module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the expansion card
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
Steps
1. Disconnect the intrusion switch cable from the connector on the rear I/O board.
190 Installing and removing system components
Before working inside your
risers.
risers.
After working inside your
Safety instructions.
Before working inside your
riser.
system.
System board jumpers and connectors
system.
system.