Dell EMC PowerEdge R750 Installation And Service Manual page 214

Figure 220. Removing the BOSS S2 module blank
To install the BOSS blank:
1. Align the blank with the BOSS S2 module bay and push it into the bay until it clicks into place.
Figure 221. Installing the BOSS S2 module blank
To install the BOSS S2 module:
1. Install the BOSS S2 module . To install the BOSS S2 , see
2. Install the M.2 SSD. To install the M.2 SSD, see
NOTE: Installing the BOSS S2 card carrier does not require the system to be powered off. System shutdown is only
required when installing the BOSS S2 controller card module.
To remove the BOSS S2 controller card module:
1. Power off the system and
2. Remove the M.2 SSD. To remove the M.2 SSD, see
214 Upgrade Kits
installing the BOSS S2 module
remove the system cover.
installing the BOSS S2 module
removing the BOSS S2 module
steps 1 to 5.
steps 6 to 10.
steps 1 to 4.