Installing the BOSS S2 module
The procedure to install is the BOSS S2 module with 4 x 2.5-inch rear drive module is same.
Prerequisites
1. Follow the safety guidelines listed in the
Safety
instructions.
2. Follow the procedure listed in the
Before working inside your
system.
3. If installed,
remove the BOSS module
blank.
Steps
1. Connect the BOSS S2 power and signal cables to the connectors on the BOSS S2 module.
Figure 189. Connecting the BOSS S2 power and signal cables to the BOSS S2 module
2. Align the BOSS S2 module at an angle with the controller card module slot.
3. Insert the BOSS S2 module and push the module horizontally towards the rear of the system until firmly seated.
4. Using the Phillips #1 screwdriver, secure the BOSS S2 module with the M3 x 0.5 x 4.5 mm screw.
5. Connect the BOSS S2 power and signal cable to the connectors on the system board.
Installing and removing system components
185