Figure 85. Installing the 4 x 2.5-inch rear drive module
Next steps
1. Connect all the cables to the rear drive module.
2.
Install the
drives.
3. If removed,
install the BOSS S2
4. If removed,
install the air
5. Follow the procedure listed in
Removing the 2 x 2.5-inch rear drive module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If required,
remove the air
4.
Remove the
drives.
5. Disconnect the cables from the rear drive module.
NOTE:
Refer
cable routing
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws that secures the rear drive module to the system.
2. Press the blue release tab and holding the edges lift the rear drive module away from the system.
86
Installing and removing system components
module.
shroud.
After working inside your
Safety
instructions.
Before working inside your
shroud.
topic for more information.
system.
system.