Figure 83. Installing a drive into the drive carrier
Next steps
1.
Install the drive
carrier.
Rear drive module
Removing the 4 x 2.5-inch rear drive module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If required,
remove the air
4.
Remove the
drives.
5. If installed,
remove the BOSS S2
6. Disconnect the cables from the rear drive module.
NOTE:
Refer
cable routing
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws that secures the rear drive module to the system.
2. Lift the rear drive module from the system.
84
Installing and removing system components
Safety
instructions.
Before working inside your
shroud.
module.
topic for more information.
system.