Figure 81. Installing a drive carrier
Next steps
If removed,
install the front
Removing the drive from the drive carrier
Prerequisites
1. Follow the safety guidelines listed in the
2.
Remove the drive
carrier.
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
NOTE:
If the drive carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screwdriver to
remove the drive.
2. Lift the drive out of the drive carrier.
82
Installing and removing system components
bezel.
Safety
instructions.