Installing The Drive Into The Drive Carrier - Dell EMC PowerEdge R750 Installation And Service Manual

Figure 82. Removing the drive from the drive carrier
Next steps
Install the drive into the drive

Installing the drive into the drive carrier

Prerequisites
1. Follow the safety guidelines listed in the
2. Remove the drive blank.
Steps
1. Insert the drive into the drive carrier with the drive connector facing towards the rear of the carrier.
2. Align the screw holes on the drive with the screws holes on the drive carrier.
3. Using a Phillips #1 screwdriver, secure the drive to the drive carrier with the screws.
NOTE: When installing a drive into the drive carrier, ensure that the screws are torqued to 4 lbf-in.
NOTE: If the drive carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screwdriver to
install the drive.
carrier.
Safety instructions.
Installing and removing system components 83