Introduction - Nortel T1/SMDI Configuration Manual

CallPilot and T1/SMDI connectivity overview

Introduction

This guide describes the steps in setting up a T1/SMDI switch or system and
configuring a CallPilot
connecting the CallPilot system to the T1/SMDI switch or system and
the Customer Local Area Network (CLAN)
configuring the T1/SMDI switch or system for correct operation with
CallPilot
configuring the CallPilot server
For a high-level overview of CallPilot and switch or system connectivity,
read the remainder of this chapter.
For a list of CallPilot documentation, see the document map on page 7.
Before you begin
Before you proceed with configuring the T1/SMDI switch or system and
CallPilot server:
review the "Installing CallPilot" section in the CallPilot Installation and
Configuration Task List
complete the "Installation and configuration checklist," on page 17
16
*
server for the CallPilot installation:
Standard 1.13
CallPilot