Nortel T1/SMDI Configuration Manual page 145

February 2008
5 Press 76 to delete the message.
Result: CallPilot plays the following prompt: Message 1 deleted.
ATTENTION
6 Press 83 and then hang up the phone.
Verifying that each call channel and multimedia channel is
functioning properly
Tests that verify the CallPilot channels confirm that the call channels and
multimedia (DSP) channels are functioning properly.
The call channel is the channel that carries the call signal from the switch to
CallPilot. The multimedia channel is the channel in CallPilot that processes
the call and provides voice, fax, or speech recognition capability.
Tests that verify the CallPilot channels consist of the following procedures:
"To test call channels and voice channels" on page 146 (Skip this
procedure if you do not have voice channels installed.)
"To test call channels and fax channels" on page 148 (Skip this
procedure if you do not have fax channels installed.)
"To test call channels and speech recognition channels" on page 149
(Skip this procedure if you do not have speech recognition channels
installed.)
"To restore the SDN Table and put all channels back in service" on page
151.
T1/SMDI and CallPilot Server Configuration
If you do not hear the exact message, Message 1
deleted, the wrong prompts are installed or CallPilot did
not install properly.
If you do not hear the correct message, contact your
Nortel customer support representative.
Testing the CallPilot installation
145