To Check Ofcvar Values; Checking Ofcvar Values - Nortel T1/SMDI Configuration Manual

February 2008

Checking OFCVAR values

Introduction
Ensure that the cutoff-on-disconnect (COD) time in table OFCVAR is set to
one second (100).

To check OFCVAR values

1 Type table ofcvar and press Enter.
2 Respond as shown in the following table:
Field Subfield Entry
PARMVAL
T1/SMDI and CallPilot Server Configuration
pos
CUTOFF_ON_DISC_TIME
cha
100
Configuring the switch
Explanation and action
Check that the value is 100
(one second). If not,
change the value to 100.
Enter cha to change the
value.
Specifies COD time for
lines assigned the COD
option.
89