Nortel T1/SMDI Configuration Manual page 184

CallPilot T1/SMDI interfaces
CallPilot SMDI interface requirements of the RS-232 link
The SMDI link interface requirements of the RS-232 are fully defined by
the EIA/TIA-232-F specification. Specific configuration settings for proper
operation of the SMDI link are as shown in the following table:.
Parameter
Data rate
Mode
Data bits
Parity
Stop bits
H/W Flow Control
S/W Flow Control
RS-232 Specification Revision #
184
Description
9600 baud
Asynchronous, full duplex
7
Enabled, Even
1
None
None
EIA/TIA-232-F
Standard 1.13
CallPilot