Led Diagnostics And Troubleshooting; Module Programming - Error Codes; External Module Synchronization - Directed XPRESSSTART ONE Installation Manual

LED diagnostics and troubleshooting

This section provides LED diagnostics and troubleshooting instructions for:
• "Module programming - Error codes"
• "External module synchronization"
• "Shutdown codes"
• "Active ground while running (status)"
• "D2D and W2W commands"

Module programming - Error codes

LED Description
CAN/J1850 not de-
tected.
Flashes red x 1
CAN2 not detected.
Flashes red x 2
Bypass data not de-
tected.
Flashes red x 3
Bypass processing
error.
Flashes red x 4
ISO 1 not detected.
Flashes red x 5
ISO 2 not detected.
Flashes red x 6
MUX not detected.
Flashes red x 7
Incorrect program-
ming sequence.
Flashes red x 8
Ignition not detected.
Flashes red x 9
VIN not supported.
Flashes red x 10
BCM not supported.
Flashes red x 11

External module synchronization

LED Description
OBDII feature not sup-
(Flashes red,
ported.
red, then
orange) x 10
11
Troubleshooting
Check the Orange/Green - Orange/Brown
wire connections. Wake up the data bus by
turning the ignition on and try again.
Check the Tan - Tan/Black wire connections.
Wake up the data bus by turning the ignition
on and try again.
Check the bypass line connection. If more
than one wire is used, make sure they are
not inverted.
Bypass calculation failed. Reset the module
and try again.
Yellow/Black wire did not detect the expect-
ed signal.
Orange/Black wire did not detect the ex-
pected signal.
Violet/Green - Violet/Brown did not detect
expected voltage value.
All functions and features have been skipped.
Module will not perform any operation.
Check the ignition input connection.
Check the firmware against vehicle year and
model coverage. Possible causes are that a
vehicle build date or a country code has yet
to be supported.
Vehicle platform is not supported by the firm-
ware.
Troubleshooting
Diagnostic data bus not detected.
Comment
Some installation types do not need this connection.
Skip by pressing the programming button 5 times.
Some installation types do not need this connection.
Skip by pressing the programming button 5 times.
Start vehicle using the key to confirm the OEM
equipment is still operational.
Might be caused by a bad reading in the first pro-
gramming attempt or by an unknown bypass value.
If a second attempt fails, connect the module to
XPRESSKIT and call Tech Support with the module
ID in hand.
Refer to the wiring installation section to check the
connections.
Refer to the wiring installation section to check the
connections.
Refer to the wiring installation section to check the
connections. Use a Multimeter to check the voltage
value on the wire.
Too many programming sequences have been
skipped by pressing the programming button 5
times. Reset module and reprogram.
Ignition can be detected from CAN or wire input.
Connect module to XPRESSKIT and call Tech Sup-
port with the module ID in hand. If applicable, the
new VIN will be added to the solution.
Connect module to XPRESSKIT and call Tech Sup-
port with the module ID in hand. If applicable, the
new VIN will be added to the solution.
Comment
Some features are not supported by SmartStart. This
can be caused by missing wire connections or mod-
ule hardware limitation. Refer to the wiring installa-
tion section to check the connections.
XpressStart ONE 4x10/5x10 Analog
© 2013 Directed. All rights reserved.