Led Diagnostics And Troubleshooting - Directed DS4+ Installation Manual

Remote start system ma3 software
Hide thumbs Also See for DS4+:
Table of Contents

Advertisement

Wait for the module to program (it may flash up to 30 seconds). The LED will turn ON
6
green for 3 seconds.
Press the Push-to-Start (PTS) button once to turn vehicle ignition OFF once the module is suc-
7
cessfully programmed.
Pair remotes (if applicable). For information on how to pair a specific remote, please
8
refer to its corresponding owner documentation, which can be found inside the product
packaging of the complete system or on www.directechs.com.*
By default, the tachometer is preprogrammed for the vehicle. For instructions on how to
9
program tach, see page 31.
You have successfully completed the module programming sequence.
* Your aftermarket remote may differ from the model shown in the illustrations.

LED diagnostics and troubleshooting

This section provides LED diagnostics and troubleshooting information to guide you through the various stages of your installation.
Module programming
LED
Description
Module has no power.
Off
Waiting to begin the programming
sequence.
Solid red
Initialization failed.
Flashes red &
green
Transponder functions were skipped.
Solid orange
All required CAN networks has been
detected.
Flashes green
1 of 2 CAN networks has been detected.
Flashes orange
Key2GO initiated.
Flashes orange
slowly
Module was successfully programmed
Solid green x
with all functions.
3 secs
Module was successfully
programmed without transponder
Solid orange x
functions.
3 secs
Module programming – Error codes
LED
Description
CAN2 not detected.
Flashes red x 1
J1850 not detected.
Flashes red x 1
CAN1 not detected.
Flashes red x 2
Bypass data not detected.
Flashes red x 3
28
Troubleshooting
Make sure the D2D harness is connected and that 12 Volt is present between the red and black
wires. If 12 Volt is present, the module may be defective.
Ensure the correct programming procedure is being followed.
Reset the module and complete the programming again. If the issue persists, please contact
Technical Support.
(If compatible) when the RXT mode is not desired or convenience features are needed, please
reset and reprogram the module.
Normal operation.
Normal operation.
Please follow the steps indicated in "Module programming" on page 27 to complete the
Key2GO programming.
Normal operation.
Normal operation.
Troubleshooting
Check the CAN2 Orange/Green and Orange/Brown wire connections. Wake up the data bus
by turning the ignition on and try again. If your installation does not require this connection, skip
this step by pressing the programming button 5 times.
Check the J1850 wire connection. Wake up the data bus by turning the ignition on and try
again.
Check the CAN1 Tan and Tan/Black wire connections. Wake up the data bus by turning the
ignition on and try again. If your installation does not require this connection, skip this step by
pressing the programming button 5 times.
Check the bypass line connection. If more than one wire is used, make sure they are not inverted.
Ensure the vehicle still operates correctly using the factory key.
Green x
3 secs.
Pair
remotes*
Initialize
tachometer
DS4+ MA3
© 2017-02-15 Directed. All rights reserved.

Advertisement

Table of Contents
loading

Table of Contents