Instructions - Directed XPRESSSTART ONE Installation Manual

Instructions

Refer to "LED diagnostics and troubleshooting" on page 11 for more information and for troubleshooting
purposes.
To connect the module:
1. Please ensure that the vehicle is in a safe location an cannot move forward during programming. For vehicles
equipped with a manual transmission, make sure the gearshift lever is in the neutral position.
2. Connect all the harnesses to the 4x10/5x10 system, EXCEPT the white12-pin main power harness.
Connect all but the white
3. Press and hold the programming button, then connect the white 12-pin main power harness.
Must be connected LAST
&
Press & Hold
4. Wait until the LED turns ON solid orange and release the programming button. The LED turns ON solid green
for 3 seconds, then OFF. If the LED does not turn ON, verify the power connections.
&
Solid
orange
Release
5. Pair remotes. For proper instructions, see "Remote pairing" on page 24.*
Pair
remotes*
6. Initialize the tachometer. For more information, see "Initializing Virtual Tach (not needed with hardwired Tach
input)" and "Learning the Tach (not needed with Virtual Tach)" on page 23.
Initialize
tachometer
* Your aftermarket remote may differ from the model shown in the illustrations.
10
12-pin harness
& &
Solid
Off
green
XpressStart ONE 4x10/5x10 Analog
© 2013 Directed. All rights reserved.