Glossary Of Terms - Directed XPRESSSTART ONE Installation Manual

Glossary of terms

Document terminology
4x10
5x10
Analog
Aux
Control Button
Control Center
Control Module
Companion Remote (1-
way Remote Control)
Config Wizard
Digital
Flex Relay
IVU
LED
LCs
LCD
MTS
N.C.
N.O.
Responder LE (2-way Re-
mote Control)
Responder LC (2-way
Remote Control)
Responder One (Remote
Control)
RS
RSS
Shutdown Toggle Switch Normally located near the control module or mounted around the dashboard, this
Status LED
28
Remote start system.
Remote start and security system.
Non digital installation type.
Auxiliary.
A small push button located on your system's control center. It is used to override (dis-
arm) the alarm when a remote is not available or to enter or exit Valet Mode.
The control center contains the system's radio-frequency antenna, the control button,
and the Status LED. For maximum remote-control range, the control center is usually
located at the top of the windshield, centered near the rear-view mirror.
The "brain" of your system. Usually hidden underneath the dash area of the vehicle. It
houses the microprocessor which monitors your vehicle and controls all of the system's
functions.
A hand-held, remote control which operates the various functions of your system but
does not provide message confirmation.
Web tool used to program the control module.
Vehicle-specific installation type.
Relay that can be programmed for Ignition, Accessory or Start.
Control Center.
Light Emitting Diode – An electronic semiconductor device that emits light when an
electric current passes through it.
Liquid Crystals.
Liquid Crystal Display – An electronic visual display that uses the light modulating
properties of liquid crystals (LCs). LCs do not emit light directly.
Manual Transmission Mode.
Normally Closed.
Normally Opened.
A hand-held LED remote control which operates the various functions of your system
and receives messages as well as pages from it, and then displays them via small LEDs
mounted on the remote.
A hand-held LCD remote control which operates the various functions of your system
and receives messages as well as pages from the it, and then displays them via small
LEDs mounted on the remote.
A hand-held 1-button remote control which operates the various functions of your sys-
tem remotely.
Remote Start.
Remote Start and Security.
Shutdown switch is used to disable the remote start feature.
A light used to indicate the status of your system. It is located on your system's Control
Center.
XpressStart ONE 4x10/5x10 Analog
© 2013 Directed. All rights reserved.