Adjusting The Shock Sensor (5X10 Only); Adjusting The Sensor; Testing The Sensor - Directed XPRESSSTART ONE Installation Manual

4x10/5x10

Hide thumbs Also See for XPRESSSTART ONE:

Table of Contents

Adjusting the shock sensor (5x10 only)

The shock sensor sensitivity can be adjusted by using a screwdriver to turn the potentiometer.

Note: It is important to choose an appropriate location to mount the sensor. Attaching the sensor to an existing

vehicle wiring harness may result in poor shock detection.

1. Disarm the system, turn the ignition Off.

2. With the sensor mounted in its permanent location, locate the potentiometer on the shock sensor module and

using a screwdriver:

• Turn the potentiometer clockwise for increased sensitivity or

• Turn it counterclockwise for decreased sensitivity

Note: You can test the new setting by cautiously impacting the vehicle with increasing intensity while noting

the LED status on the shock sensor. The LED turns on for a short duration for small impacts before turning off

(indicating a warn-away trigger). The impact level required to fully trigger the alarm is indicated when the LED

remains on for a longer duration before turning off.

Note: This adjustment cannot be performed using the remote control.

If testing while the system is armed:

1. Wait at least 15 seconds after arming before impacting the vehicle.

2. Cycle the ignition On/Off regularly to reset the Nuisance Prevention Circuitry® (NPC) feature.

XpressStart ONE 4x10/5x10 Analog

Table of Contents