Programmable Features; Programmable Outputs; Output Descriptions - Directed XPRESSSTART ONE Installation Manual

Programmable features

The following requirements are mandatory for the successful configuration of the programmable features: an
XKLoader2 module, the XpressVIP application (version 4.3 or higher), and a web connection.

Programmable outputs

The programmable outputs can be programmed to provide the following types of functions:
• Factory Alarm Arm
• Active When Armed
• Factory Alarm Disarm
• Lock
• Active When Locked
• Unlock
• 2nd Unlock
• Active When Unlocked by User 2
• Trunk Release
• Aux 1
• Aux 2
• Aux 3
• Aux 4
• Ground While Running

Output descriptions

Output
Factory Alarm Arm
Active When Armed
Factory Alarm Disarm
Lock
Active When Locked
Unlock
2nd Unlock
Active When Unlocked by
User 2
Trunk Release
Aux 1
Aux 2
Aux 3
Aux 4
Ground While Running
Ground While Running
(5 sec)
Smart Key Control (for PTS)
Pulse After Startup
14
Description
Sends a pulse every time the remote starter shuts down or the doors are locked using the remote.
Supplies an output as long as the system is armed. This output ceases as soon as the system is disarmed.
Sends a pulse every time the remote starter is activated or the doors are unlocked.
Provides a lock pulse (see the Feature Programming for Lock).
Supplies an output as long as the module is locked.
Provides an unlock pulse (see the Feature Programming for Unlock).
Provides a pulse on 2nd Unlock press from remote (useful for progressive locks).
Supplies an output as long as the module is unlocked by remote 2 until the module is locked again.
When the system receives the AUX/Trunk command for longer than 1.5 seconds, the wire will supply an output
for a minimum of 0.8 seconds and will continue until the AUX/Trunk command ceases.
Provides an output each time the AUX1 button is pressed (see the Feature Programming for AUX1).
Provides an output each time the AUX2 button is pressed (see the Feature Programming for AUX2).
Provides an output each time the AUX3 button is pressed (see the Feature Programming for AUX3).
Provides an output each time the AUX4 button is pressed (see the Feature Programming for AUX4).
Supplies an output as soon as the module begins the remote start process. The output will be activated before
the ignition output is turned on, and deactivated after the ignition is turned off.
Supplies an output for 5 seconds as soon as the module begins the remote start process.
Supplies one pulse after the module ends the remote start process when it turns off. This function is very useful
for cars equipped with a Push-to-Start system.
Supplies a 1-second output immediately following the end of the starter output during remote start.
• Ground While Running (5 seconds)
• Pulse Before Starting
• Smart Key Control (for PTS)
• Pulse After Startup
• Pulse After Ignition Off (pulse duration = 1 min.)
• Accessory
• Ignition
• Starter
• Parking Lights
• Rear Defroster
• Dome Light
• Horn
• Active When Alarm Triggered
• Anti-grind (H3/6 - Orange/Black only)
XpressStart ONE 4x10/5x10 Analog
© 2013 Directed. All rights reserved.