Menu 2 - Remote Control Config; Initializing Virtual Tach (Not Needed With Hardwired Tach Input) - Directed XPRESSSTART ONE Installation Manual

OEM FOB Control (3X Lock Start)
Note that the availability of features and their predetermined default values is in direct relation to the firmware
you are using.
Default settings are in bolder type.
Menu
Feature
Item
1 Enabled
2 Timeout
Note: Features can only be programmed via the web tool. See "Connecting the module" on page 9 for more
information.
1 Enabled
2 Timeout

Menu 2 - Remote control config

Note that the availability of features and their predetermined default values is in direct relation to the firmware
and remote you are using.
This page allows you to configure the:
• Remote commands
• Programming outputs

Initializing Virtual Tach (not needed with hardwired Tach input)

To program Virtual Tach:
1. After the install is complete, remote start the engine. The programming operation may require 3 cranks of the
starter before the engine starts and runs. Do not turn off the remote start if this happens, it is a normal program-
ming operation.
2. Once the engine begins running, let it run for at least 30 seconds.
3. Using the Remote, send the Remote start command to turn remote start off. Virtual Tach is programmed. To reset
Virtual Tach, go into the Reset and Deletion section of this guide.
Note: Virtual Tach cannot be used in MTS Manual Transmission Mode. It is also not recommended for diesel trucks.
Virtual Tach handles disengaging the starter motor during remote starting – it does not address over-rev. If the cus-
tomer wants to have the over-rev protection capability, the tach wire must be connected.
Important! After successfully learning Virtual Tach, a small minority of vehicle starters may over crank or under
crank during remote start. Use the VirtualTach Fine tune feature to adjust the starter output time in 50mS increments
to compensate for such an occurrence.
22
Opt. 1 Opt. 2
Check box not
Check box se-
selected for
lected for Enabled
Disabled
Options: 2 to 10 seconds. The default value is 4 seconds.
1. Enabled
2. Disabled
2 to 10 seconds: sets the low temperature threshold required for SmartStart to turn the engine on. The
default value is 4 seconds.
Opt. 3 Opt. 4 Opt. 5+
XpressStart ONE 4x10/5x10 Analog
© 2013 Directed. All rights reserved.