Main Module Connections - Directed XPRESSSTART ONE Installation Manual

Main module connections

Manual/Auto Transmission Type Selector
Uncut: Manual Type - Cut: Automatic Type
(See Connecting the module section)
Auxiliary Output Harness (H2)
16 pins, Black
Future Use
3 pins, White
Satellite Relay Harness
7 pins, White
Analog Harness (H3)
18 pins, White
Transponder RF Loop
2 pins, White
5
Manual/Auto. Transmission Type
Main Ignition Harness (H4)
8 thick-gauge wires
Programming Button
(Used to reset the
firmware programming)
Prog.
Button
RF Harness
6 pins, Green
Not Used
2 pins, Black
SmartStart/XKLoader2 Port
4 pins, White
Sensor Port (RSS)
4 pins, Red
Main Power
Harness (H1)
12 pins, White
IVU
NOT included
The XKLoader2 is required
to program the unit. It
must be disconnected at
the time of installation.
XpressStart ONE 4x10/5x10 Analog
© 2013 Directed. All rights reserved.