Led Diagnostics & Troubleshooting - Directed XPRESSKIT DBALL Installation Manual

Platform: DBALL/DBALL2
Firmware: CHRYSLER
LED Diagnostics & Troubleshooting
LED Status
Module Programming
Off
Off
Solid red
Solid
Flashes orange
Flashes
Flashes green
Flashes
Solid green for
Solid
x3 secs
3 seconds
Solid orange for
Solid
x3 secs
3 seconds
Active Ground While Running
Flashes green
Flashes
Flashes red &
orange
Flashes
Flashes green
Flashes
quickly
quickly
Inactive Ground While Running
Flashes orange
Flashes
x1
x1
Flashes orange
Flashes
x2
x2
Flashes orange
Flashes
x3
x3
Flashes orange
Flashes
x4
x4
Flashes orange
Flashes Flashes
x5 x5
x5
External Module Synchronization
Flashes red,
Flashes
red, red
red and orange
and
orange
x10
Description
Module has no power.
The bus type cannot be detected.
The vehicle type cannot be
detected.
Waiting for keyless.
Module was successfully
programmed or is already
programmed.
Module was successfully
programmed without diagnostics.
GROUND OUT ON (GWR)
command received.
IGNITION ON command received.
START ON command received.
Lock command has been received
Unlock command has been
received
Trunk command has been received
AUX1 command has been received
AUX2 command has been received
OBDII feature not supported.
Diagnostic data bus not detected.
Troubleshooting
Check the power connections.
Make sure the connections to the data bus are correct
and insert the key in the ignition switch.
Insert the key in the ignition switch and turn to the ON
position. You may need to wait up to 10 seconds.
Remove the key from the ignition switch and press a
keyless button.
Normal operation.
Normal operation.
Otherwise, the Ground While Running (status) signal
was lost or was never received by the module.
Commands can come from RF, D2D or W2W.
Otherwise, the ignition signal was not received by the
module. In a W2W install, it will show only if the ignition
input wire is used.
Otherwise, the start signal was not received by the
module. In a W2W install, it will show only if the ignition
input wire is used.
Normal operation.
Some features are not supported by SmartStart. This
can be caused by missing wire connections or module
hardware limitation. Refer to the wiring installation
section to check the connections.
Rev.: 20150128
Page 24
© 2015 Directed. All rights reserved.