Wiring Connections; Main Power Harness (H1), 12-Pin Thick Gauge Connector; Auxiliary Output Harness (H2), 16-Pin Black Connector - Directed XPRESSSTART ONE Installation Manual

Wiring connections

The wiring connections listed below are generic to this firwmare. Refer to each installation type to see whether
they are required for your vehicle.

Main power harness (H1), 12-pin thick gauge connector

* These outputs are configurable by the installer when the module is flashed.
Conn./Pin Color
H1/1 WHITE
H1/2 WHITE/BROWN
H1/3 BROWN/RED
H1/4 YELLOW/RED
H1/5 ORANGE/RED
H1/6 YELLOW
H1/7 WHITE
H1/8 WHITE/BROWN
H1/9 BLACK
H1/10 RED
H1/11 ORANGE/YELLOW
H1/12 BROWN

Auxiliary output harness (H2), 16-pin black connector

* These outputs are configurable by the installer when the module is flashed, and are low current. Use a relay if
necessary.
Conn./Pin Color
H2/1 VIOLET/BROWN
H2/2 YELLOW/BLACK
H2/3 ORANGE/BLACK
H2/4 TAN
H2/5 TAN/BLACK
H2/6 LIGHT GREEN
H2/7 ORANGE/GREEN
H2/8 ORANGE/BROWN
H2/9 VIOLET/GREEN
H2/10 LT. GREEN/WHITE
H2/11 WHITE/VIOLET
H2/12 WHITE/RED
H2/13 LT. GREEN/BLACK
H2/14 GREEN/RED
H2/15 VIOLET/RED
H2/16 VIOLET/YELLOW
6
Description
COMMON RELAY 3 – PARKING LIGHT OUTPUT
N.O. RELAY 3 – PARKING LIGHT INPUT
N.O. RELAY 2*
COMMON RELAY 2*
N.C. RELAY 2*
COMMON RELAY 1*
COMMON RELAY 3 – PARKING LIGHT OUTPUT
N.O. RELAY 3 – PARKING LIGHT INPUT
(-) GROUND
(+) POWER 12V
N.C. RELAY 1*
N.O. RELAY 1*
Description
No connection
No connection
No connection
No connection
No connection
No connection
No connection
No connection
No connection
(-) FACTORY ALARM ARM OUTPUT
(-) AUX 1 OUTPUT*
(+) AUX 1 OUTPUT*
(-) FACTORY ALARM DISARM OUTPUT
(+) AUX 4 OUTPUT*
No connection
No connection
XpressStart ONE 4x10/5x10 Analog
© 2013 Directed. All rights reserved.