Warning! Safety First - Directed XPRESSSTART ONE Installation Manual

Warning! Safety first

The following safety warnings must be observed at all times:
• Due to the complexity of this system, installation of this product must only be performed by an authorized Di-
rected dealer.
• When properly installed, this system can start the vehicle via a command signal from the remote control. There-
fore, never operate the system in an area that does not have adequate ventilation.
The following precautions are the sole responsibility of the user; however, authorized Directed dealers should:
• Never use a test light or logic probe when installing this unit. Always use a multimeter.
• Never operate the system in an enclosed or partially enclosed area without ventilation (such as a garage).
• When parking in an enclosed or partially enclosed area or when having the vehicle serviced, the remote start
system must be disabled using the installed toggle switch. It is the user's sole responsibility to properly handle
and keep out of reach from children all remote controls to assure that the system does not unintentionally remote
start the vehicle.
• USER MUST INSTALL A CARBON MONOXIDE DETECTOR IN OR ABOUT THE LIVING AREA ADJACENT TO
THE VEHICLE. ALL DOORS LEADING FROM ADJACENT LIVING AREAS TO THE ENCLOSED OR PARTIALLY
ENCLOSED VEHICLE STORAGE AREA MUST REMAIN CLOSED AT ALL TIMES.
Use of this product in a manner contrary to its intended mode of operation may result in property damage, personal
injury, or death. Except when performing the Safety Check outlined in this installation guide, (1) Never remotely
start the vehicle with the vehicle in gear, and (2) Never remotely start the vehicle with the keys in the ignition. The
user is responsible for having the neutral safety feature of the vehicle periodically checked, wherein the vehicle
must not remotely start while the car is in gear. This testing should be performed by an authorized Directed dealer
in accordance with the Safety Check outlined in this product installation guide. If the vehicle starts in gear, cease
remote start operation immediately and consult with the user to fix the problem immediately.
After the remote start module has been installed, test the remote start module in accordance with the Safety Check
outlined in this installation guide. If the vehicle starts when performing the Neutral Safety Shutdown Circuit test, the
remote start unit has not been properly installed. The remote start module must be removed or properly reinstalled
so that the vehicle does not start in gear. All installations must be performed by an authorized Directed dealer.
OPERATION OF THE REMOTE START MODULE IF THE VEHICLE STARTS IN GEAR IS CONTRARY TO ITS IN-
TENDED MODE OF OPERATION. OPERATING THE REMOTE START SYSTEM UNDER THESE CONDITIONS
MAY RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY. IMMEDIATELY CEASE THE USE OF THE UNIT AND
REPAIR OR DISCONNECT THE INSTALLED REMOTE START MODULE. DIRECTED WILL NOT BE HELD RESPON-
SIBLE OR PAY FOR INSTALLATION OR REINSTALLATION COSTS.
Remote starters for manual transmission pose significant risks if not properly installed and operated. When testing
to ensure the installation is working properly, only remote start the vehicle in neutral gear, on a flat surface and with
a functional, fully engaged parking brake. Do not allow anyone to stand in front of or behind the vehicle.
This product should not be installed in any convertible vehicles, soft or hard top with a manual transmission. Instal-
lation in such vehicles may pose certain risk.
3
XpressStart ONE 4x10/5x10 Analog
© 2013 Directed. All rights reserved.