Table of Contents
Advertisement
2
Make sure the paper thickness lever is
e
set to
(down).
• For details, 1 p. 5-6.
c
Do not set the paper thickness lever
while the unit is printing since this
will cause problems.
3
Cut the banner paper along one of the
perforations to the length required. Then
gently fold along the perforations
between the first and second sheets.
• Your banner can be up to six sheets
(1782 mm) long.
4
Place the banner paper behind the unit
on a flat surface. Then insert the first
sheet into the multi-purpose tray q, and
align the right edge of the sheet with the
right side of the multi-purpose tray. Slide
the paper guide against the left edge of
the sheet, leaving a 1 mm gap between
the paper guide and the edge of the
sheet w.
• Make sure the sheet is under the tabs on
the multi-purpose tray.
• Make sure the sheets behind the unit are
aligned with the multi-purpose tray.
5
Your MultiPASS is now ready to print.
Set your PC to print on the banner paper.
• Allow the paper to flow over the edge of the
table as it exits the MultiPASS.
Chapter 5
1
2
TABS
Paper Handling
5-13
Advertisement
Table of Contents
