Table of Contents
Advertisement
Using Coded Speed Dialling
To use this feature, you must first register a number for coded speed dialling.
(1 p. 6-6)
Follow this procedure to send documents using coded speed dialling:
1
Open the document tray.
2
Adjust the document feed lever for the
document you are loading. (1 p. 4-2)
3
Prepare the document and load it, face
down, in the ADF. (1 p. 4-4)
• For colour sending, press Colour/B&W to
turn its light. (1 p. 7-2)
• To adjust the resolution and contrast,
1 pp. 7-3, 7-4.
4
Press Coded Dial.
5
Use the numeric buttons to enter the two-digit
code assigned to the number you wish to fax.
• The number registered under that coded
speed dialling code is displayed.
• If you enter the wrong code, press Stop. Then
press Coded Dial and enter the correct code.
• NO TEL # appears if no fax number is
assigned to the coded speed dialling code you
entered.
6
Press Start to begin scanning for sending,
or wait a few seconds for the MultiPASS to
begin scanning automatically.
• If you prefer the MultiPASS never to scan a
document automatically after a few seconds,
disable the TIME OUT setting. (1 p. 14-6)
n
• You can also use coded speed dialling to send a document to more than one destination
at a time. (1 p. 7-13)
• To dial a telephone number registered for coded speed dialling, simply lift the handset,
press Coded Dial, and enter the two-digit code.
6-8
Speed Dialling
MEMORY USED 0%
(Currently used memory)
DOCUMENT READY
(Standby to scan)
A
Ex:
A01
Ex:
TEL=03 3758 2111
Chapter 6
Advertisement
Table of Contents
