Table of Contents
Advertisement
9
Press Set.
10
Press Stop to return to standby mode.
n
When the RX MODE setting is set to NET SWITCH, no other receive mode can be
selected with the Receive Mode button.
Network Switch System Operation
The procedure for using the network switch system is almost the same as when using
the MultiPASS over a normal telephone line. When you receive calls, however, the unit
will respond slightly differently as described below:
When you hear the telephone call ring pattern:
Pick up the handset and talk normally. If you hear a slow beep, it means the call is from
a fax machine trying to send a fax. Press Start to receive the fax. If you do not pick up
the handset, the unit continues to ring until the other party hangs up. If an answering
machine is connected, it takes over the call.
When you hear the fax call ring pattern (triple ring):
After the unit rings, it receives the document automatically.
Chapter 8
INCOMING RING
Ex:
15:00
NET SW.
Receiving Faxes
8-15
Advertisement
Table of Contents
