Canon MultiPASS C100 User Manual page 30

8
Start with the Yellow BJ tank.
Remove the packing film by pulling on
the orange tape q. Then grip the bottom
of the BJ tank and twist off the orange
protective cap in the direction shown w.
• Carefully remove the packing film taking care
not to remove the label from the BJ tank.
• Discard the packing film and cap. Never
attempt to reattach them to the BJ tank.
• Do not touch the ink port on the BJ tank.
• Spilled ink can stain any surface; protect
yourself and your work area.
9
Insert the Yellow BJ tank into the far
right slot on the BJ cartridge, then press
it down from the top until it clicks into
position.
10
Repeat steps 8 and 9 to install the
Magenta BJ tank, then the Cyan BJ tank,
and finally the Black BJ tank. Be sure to
install them in this order and to insert
them in the slots from right to left.
• Do not use the BJ cartridge with any of its
BJ tanks missing as this can cause the BJ
cartridge to clog.
11
Close the printer cover.
• The LCD displays CART. RETURN while the cartridge holder moves to its home position
on the right side of the unit. The MultiPASS then cleans the print head which takes about
20 seconds.
12
Close the document tray.
n
If you need to unplug the MultiPASS, wait until the unit is in standby mode (time and
receive mode displayed in the LCD). Otherwise the cartridge holder may not be in its home
position causing the BJ cartridge to remain uncapped and dry out.
2-16
Setting Up
2
1
TO PREVENT INK SPILLS, DO NOT
PRESS THE SIDES OF THE BJ TANK.
Ink Tank Ink Tank Ink Tank Ink Tank
BCI-3eBK BCI-3eC BCI-3eM BCI-3eY
Black Cyan Magenta Yellow
Made in Japan Made in Japan Made in Japan Made in Japan
PUSH PUSH PUSH PUSH
BLACK YELLOW
CYAN MAGENTA
Chapter 2