Intercom Control As Viewed By Internal User - 2N IP Style Installation Manual

3.3 Intercom Control as Viewed by Internal
User
Call Answering
You can answer incoming calls from
You can unlock the door, activate/deactivate a user/profile via your phone keypad
during the call. The calls, however, are time-limited to avoid unintentional blocking of
®
the 2N IP Style line. Set the maximum call duration in the Call time limit parameter
(refer to Subs. Phone / Calls
anytime to extend the call time. The automatic call termination is signaled with a short
beep 10 s before the call end.
Calling to 2N ® IP Style
®
2N IP Style allows you to answer incoming calls. Set the required parameters in the
Incoming calls group (refer to Subs.
Door Opening (Switch Activation) by Code
®
2N IP Style is equipped with a door unlocking switch. Enter the valid code (refer to
Subs. Hardware / Switches
activate this switch.
Procedure:
Enter the switch 1 or 2 activating code using your phone keypad and press
for confirmation. (Confirmation is unnecessary if the Lock code without
confirmation is enabled, refer to the Hardware / Switches / Advanced
subsection).
A valid code is signaled acoustically
than as defined in
.
2N TELEKOMUNIKACE a.s., www.2n.cz
®
2N IP Style
of the Configuration Manual). Press # on your phone
Phone / Calls
of the Configuration Manual) using your phone keypad to
Timeout for Entering Numbers
using your phone like any other calls.
of the Configuration Manual).
. An invalid code or interruption longer
, is signaled acoustically
91/105