2N IP Style Installation Manual page 77

Green LED Red LED
on off
flashing flashing
on flashing
Configuration:
®
Connect 2N Security Relay
Configuration Manual for 2N IP Intercoms
is on or flashing.
Press and hold the
the programming mode (both the red and green LEDs are flashing).
Activate the switch output using the keypad, phone, etc. The first code sent from the
intercom will be stored in the memory and considered valid. After code initialization,
®
2N Security Relay
2N TELEKOMUNIKACE a.s., www.2n.cz
Status
Activated output
Programming mode – waiting for initialization
Error – wrong code received
to the properly set Security intercom output. Refer to the
®
2N Security Relay
will pass into the operational mode (the green LED is flashing).
for details. Make sure that one LED at least
Reset button for 5 seconds to put the device in
77/105