Accelerating Rollers Controls - GBC DELTA Operator's Manual

Table of Contents

Service Manual – Mechanical

2.9

ACCELERATING ROLLERS CONTROLS

A section view of the accelerating rollers controls is shown below.

Maintenance should be performed as follows:

1. Disassemble the sheet metal safety cover.

2. Change the defective components.

3. Install the sheet metal safety cover.

The mechanism is driven by the pneumatic cylinder (f) on the driving side. The gate II mechanism is

controlled by the control system and is set by the manufacturer. The position of rollers is set by the

manufacturer and the adjustment should not be changed.

If the compressed air is cut off to the pneumatic roll (f), the spring (h) retracts the pressing roller so that

it does not contact and deform the feeding roller. Ensure that the spring is in good working order.

Only a technician trained by a GBC Service technician can change the pneumatic cylinders or

electromagnetic valves.

Pneumatic cylinder controlling the accelerating roller

Delta Laminator

Table of Contents

Table of Contents