Feeder Head; Feeder Head Positioning; Feeder Head Adjustment - GBC DELTA Operator's Manual

Delta Laminator

8. FEEDER HEAD

8.1

FEEDER HEAD POSITIONING

Loosen the clamp with the handle (a). Move the head to the rear position (off the machine). Lift the
table with a paper stack to the working position by pressing the "STACK UP" button. (See the
illustration in Chapter 4.1.) Move the head so that the rear stops (b) will touch the rear edge of the
paper stack slightly and then tighten the handle (a).
d
8.2

FEEDER HEAD ADJUSTMENT

The feeder head foot (c) has to be on top of the paper stack. Move the flat springs (d) onto the stack so
that their front edge will exceed the paper edge by approximately 5/32 to 9/32 in. (4 to 7 mm) and so
that they will be located by 5/32 to 15/64 (4 to 6 mm) above the stack. The height of the flat springs (d)
have to be adjusted so that separating the different sheets will be assured.
© 2004 General Binding Corporation
c
b
Operator Manual
a
43