Pressure Roller Replacement; Snapping Roller Belt - GBC DELTA Operator's Manual

Service Manual – Mechanical

2.13 PRESSURE ROLLER REPLACEMENT

2.13.1 Pressure roll disassembly and assembly
The following should be performed by two people. To reassemble the pressure roll, reverse the steps.
1. Put two 1/2 x 2 in. x 4 ft. (10 x 50 mm x 1.2 m) bars under the pressure roller.
2. Disconnect the pneumatic cylinder pins from the pressure roller arms.
3. Unscrew the two pressure roller arm pivots from both arms of the pressure roller.
4. Roll the pressure roller with the arms from the front position to the gap between the
laminator and separator, and take them out of the machine.

2.14 SNAPPING ROLLER BELT

Assembly and disassembly can be performed only by a technician trained by a GBC Service
technician. If a belt fails, it must to be changed. The proper belt type is given in the parts catalog and it
is also printed on the upper surface of the belt. All the tighteners need to be loosened when the belts
are changed.
16
Delta Laminator
© 2004 General Binding Corporation