GBC DELTA Operator's Manual page 50

Delta Laminator
9.2.4 SHEET OVERLAP SENSOR
The sheet overlap sensor protects the supporting pressure roll and prevents the film from sticking to its
surface.
Check its function daily after the machine is turned on. To do this, start the machine and put a separate
sheet of paper between the receiver and sender of the SQ4 sensor. Remove the sheet. The machine
should stop and the message, "Missing sheets," will display on the operator's panel.
The sensor can be repaired only by a GBC service technician.
c
a
b
© 2004 General Binding Corporation
d c
b
Operator Manual
a c
51