GBC DELTA Operator's Manual page 49

Operator Manual
Pressure
The pressure is determined by the upper (ch) guide position. Refer to the following illustration. The
screw (i) should be loosened first.
The adjustment should be done as follows:
1. Load one sheet of the paper in the machine.
2. Stop the machine when the paper is under the upper guides
3. Loosen the screw (i).
4. Adjust the upper guide position so that it contacts the paper and the sheet can slide back
and forth.
5. Tighten the screw (i).
NOTE: If a smaller size is used, move the upper guides first. Then turn the knob for moving the side
guides.
50
j
Delta Laminator
i
ch
© 2004 General Binding Corporation