Safety Notices - Twin Knife - GBC DELTA Operator's Manual

Delta Laminator
1.9 SAFETY NOTICES – TWIN KNIFE
The cutting knives are covered with Plexiglas at the top and at the sides. Since the knives are very
sharp and they move very fast the following rules must be obeyed.
WARNING
!
Obey the following precautions. Failure to do so can result in severe personal injury or damage the
machine.
•
Never put your fingers or other part of the body close to the safety cover of the twin knives if the
machine is in operation.
•
Never put your fingers or any objects under the Plexiglas cover if the machine is not
disconnected from the power supply.
•
Use a 4 mm Allen wrench to adjust the knife position. The wrench can be put through the oval
holes at the upper part of the twin knife Plexiglas cover.
•
Do not touch the sharp edges of the knives during adjustment or changing of the knives. The
knives can be held only away from the sharp edges.
•
When handling the knives, put them in a safe place outside of the machine where no one can
get injured.
•
The solid safety Plexiglas cover must be installed every time when new or original knives are
tested or adjusted.
•
If another operation near the knife should be performed, disconnect the power supply.
•
The Plexiglas cover must be always installed if the machine is in operation.
•
The cover must not be modified otherwise than provided by the manufacturer.
Important
•
Do not put any objects on the surface of the Plexiglas cover, which could deform or damage the
cover.
© 2004 General Binding Corporation
Operator Manual
!
WARNING
Keep fingers away from
the twin knives.
Twin knives move very
fast under the Plexiglas
cover.
19