GBC DELTA Operator's Manual page 37

Operator Manual
Problem: THE SHEETS ARE RAGGED ON THE SIDE BY THE SEPARATOR KNIFE
Solution: The problem is caused by:
- Too small gap between the sharp blade edge and guide pin
Two clamping screws M5 on the knives have to be loosened, the knife turned off the guide pins, and
then the screws must be tightened again.
If turning the knives will not resolve the problem, the knives have to be raised up by forming metal
sheet inserts 0.01 in. (0.3 mm thick). (Explanation on the knife position is given in Chapter 13.3.)
38
Delta Laminator
© 2004 General Binding Corporation