Safety Notices; Safety Notices -Service Maintenance And Adjustment - Complete Machine - GBC DELTA Operator's Manual

Delta Laminator

1. SAFETY NOTICES

The safety notices in this chapter apply to the mechanical and electrical sections of this service manual.
1.1 SAFETY NOTICES –SERVICE MAINTENANCE AND ADJUSTMENT –
COMPLETE MACHINE
!
WARNING
Obey the following precautions. Failure to do so can result in severe personal injury or damage the
machine.
•
Do not adjust any mechanism while the machine is in operation. The machine must be stopped,
adjusted, and only then restarted.
•
The machine cannot be adjusted, maintained, repaired, etc. by anyone under the influence of
alcohol, drugs or some medications.
•
Do not take the covers off if the machine is in operation.
•
Do not start the machine with dismantled covers.
•
The machine must be stopped and the switch secured before performing maintenance or
adjustment.
•
Do not perform maintenance on the machine if the temperature of the laminating roller surface
exceeds 122 °F (50°C).
•
The laminating roller temperature can be checked by:
The temperature value on the control panel temperature regulator
With an external temperature measuring instrument
If the temperature of the laminating roller surface according to of the above point cannot be
assured, maintenance or adjustment cannot be performed until 60 minutes after the
roller heater has been turned off.
•
Do not wear loose fitting clothes while you perform maintenance or adjust the machine.
•
Use proper tools for maintenance and adjustment. Improper tools may cause injury.
•
Use the eye protective shield while putting on springs.
•
Maintenance and adjustment can be done only by a technician trained by GBC Service.
© 2004 General Binding Corporation
Service Manual – Mechanical
3