Features Guide E-Stop; Safety Shield Interlock Latch; Safety Shield; Feed Table - GBC TALON 44 Operation And Maintenance Manual

(1)
(2)
(A)
Fig. 13
(1)
(C)
(2)
Fig. 14
(E)
(D)
Fig. 15
28
(2)
(1)
(B)
(F)
FEATURES GUIDE
A. E-STOP: (Figure 13) Two E-
STOP buttons exist on the
laminator. One on each side of the
upper cabinet.
To engage (1), press either push
button, roller movement is stopped.
To disengage (2), turn the push
button clockwise once the
emergency condition has been
resolved.
B. SAFETY SHIELD INTERLOCK
LATCH: (Figure 14) Used to lock
the safety shield into position and
activate an interlock switch. The
interlock latch is located on the left
side of the safety shield. When
pushed to the full left (1), the
safety shield is locked. When
pushed to the full right (2), the
safety shield is unlocked.
C. SAFETY SHIELD: (Figure 14)
Prevents entanglement, entrapment
and inadvertent contact with the
heat rollers. The laminator will
operate only when the Safety
Shield is located in the fully
locked position.
To remove the safety shield, unlock
the safety shield interlock latch and
lift the safety shield (1) up and
away from the safety shield
mounting pins (2).
D. FEED TABLE: (Figure 15) The
Feed Table is used to position items
for lamination. The laminator will
operate only when the Feed
Table and Feed Table Latch are
properly installed.
E. HEAT ROLLERS: (Figure 15)
Silicone rubber coated steel tubes
heat the laminating film and
compress the heated film to the
items being laminated. Heat is
provided by an internal heating
element. The heat rollers are motor
driven for ease of loading new film.
F. PULL ROLLERS: (Figure 15) The
pull rollers, located at the back of
the laminator, are motor driven.
They simultaneously pull the film
and improve the quality of the
laminated item.
I