GBC DELTA Operator's Manual page 62

Delta Laminator
Creating the paper wave in front of the snapping rollers
Snapping
roller
Separation of some films will improve with the use of the skewing wheel. Place the wheel on the drive
side of the paper and apply just enough pressure to create a 1/2 in. (10 mm) wave in the paper just in
front of the snapping rollers to separate the sheets.
The wave is made by adjusting the directioning roller on the edge of the paper band and with its
directioning in the path out of the machine. (Only a mild adjustment is enough.)
Optional skewing section
An additional skewing section can be mounted behind the snapping section to make sheet separation
easier for special films.
Optional skewing
section
Optional
skewing wheel
© 2004 General Binding Corporation
Roller thrust Skewing
regulator wheel
Operator Manual
Wave on Directioning
the paper safety screw
63