GBC DELTA Operator's Manual page 43

Operator Manual
•
The brushes (e) should exceed the paper edge by 5/64 to 7/64 in. (2 to 3 mm) and they should
sit on the paper only lightly to prevent blowing the paper out. (Use only brushes instead of flat
springs for a heavier paper weight.)
•
Adjust the pipe blow (f) with the nut (g) so that 10 to 20 sheets at the top will be blown.
•
Adjust the inner suction cups by deflecting the plot (ch) so that the paper sheets between the
suction cups will be tightened.
•
Adjust according to the type of paper the vacuum that is necessary for the sheet intake by the
transport suction cups with the regulator. The regulator is located on the air compressor. Check
the vacuum value on the manometer (i). Refer to the photo in Chapter 8.3.
•
The regulators (j) and (k) are used for adjusting the requested pressure of air for blowing the
sheets apart.
•
The regulator (l) is used for adjusting the stack working height in the automatic mode.
g
k
j
f
44
e
b
d
c
f
© 2004 General Binding Corporation
Delta Laminator
l
e