GBC DELTA Operator's Manual page 48

Delta Laminator
Operator Manual
9.2.3 upper guides
The upper guides (c) hold the paper to the bottom guide plate so that sheets will not jump over the gate
II.
Position
There are three upper guides on the machine. The position of the center one is set by the manufacturer
and does not change. The position of the outside holders should be changed according to the paper
width. They should be adjusted so that they are approximately 13/32 in. (10 mm) from the sheet edge.
Loosen the screws (j) and then move them.
10 10
© 2004 General Binding Corporation 49