Safety Notices - Decurling Bar Adjustment; Safety Notices - Snapping Roller Zone - GBC DELTA Operator's Manual

Operator Manual
1.7 SAFETY NOTICES – DECURLING BAR ADJUSTMENT
During laminating there is an internal tension between the paper and laminating film causing it to curl
up. The sheets are straightened by the decurling bar so that they will be straight after laminating.
The following safety rules must be observed while adjusting the decurling bar position.
Important
•
Be careful while changing the control lever position. A fast movement of the control lever could
hit the decurling bar locking lever.
•
While changing the decurling bar position, do not get your fingers close to the slot in the
regulating flange.
1.8 SAFETY NOTICES – SNAPPING ROLLER ZONE
In order to assure the machine functionality, it is not possible to cover the zone near the snapping roller
completely. Therefore it is necessary to strictly obey the following safety rules.
!
WARNING
Obey the following precautions. Failure to do so can result in severe personal injury or damage the
machine.
•
Never adjust the snapping roller mechanism while the machine is running. If the levers of the
upper snapping roller move, your fingers can get pinched between the levers and the Plexiglas
cover.
•
Keep your hands and body away from the surface between the upper and lower snapping
rollers.
•
The Plexiglas cover above the snapping roller must be always closed if the machine is in
operation.
•
If the snapping roller Plexiglas cover is opened, make sure it is fully opened so that the flat
spring secures it.
•
Do not remove the cover.
Important
•
Do not put any objects on the top surface of the Plexiglas cover, which could deform or damage
the cover.
16
Delta Laminator
© 2004 General Binding Corporation