Safety Shield; Feed Table; Chill Idler; Film Shaft - GBC Falcon 60+ Operation Manual

Operations Manual
(H)
(J)
(G)
(I)
(M)
(K)
©2004 General Binding Corporation
(1)
(F)
(2)
Fig 11
(I)
Fig 12
(L)
(M)
Fig 13
FALCON
F. SAFETY SHIELD: (Figure 11) Prevents entanglement,
entrapment and inadvertent contact with the heat rollers.
The laminator will operate normally only when the
Safety Shield is located in the fully locked and closed
position. When shield is open, the laminator will only
run at 1 mpm (approximately 3.25 ft/m).
To remove the safety shield, unlock the safety shield inter-
lock latch and lift the safety shield (1) up and away from
the safety shield mounting pins (2).
G. FEED TABLE: (Figure 12) The Feed Table is used to
position items for lamination. To pivot the feed table, remove
the safety shield, lift up on the feed table, pull back, then
carefully lower. The laminator will operate only when the
Feed Table is properly installed.
NOTE: You can not raise or lower the main roller with
the table pivoted.
H. CHILL IDLER: (Figure 12) Assist in the cooling process
of the web material as it exits the heat rollers.
To remove the chill idler, lift the chill idler straight up and
out from the chill idler brackets.
I. FILM SHAFT: (Figure 12) The film shaft holds the film
supply on the machine.
J. MAIN ROLLERS: (Figure 12) Silicone rubber coated
steel tubes heat the laminating film and compress the
heated film to the items being laminated. Heat is provided
by an internal heating element. The heat rollers are motor
driven for ease of loading new film.
K. IDLER BAR: (Figure 13) The idler bars, located near
each heat roller, are used to direct the film to the heat roller
nip. The bottom Idler Bar is movable to ease film loading.
L. PULL ROLLERS: (Figure 13) The pull rollers, located at
the back of the laminator, are motor driven. They simultane-
ously pull the film and improve the quality of the laminated
item.
M. REWIND TUBE: (Figure 13) The front rewind tube is
used to rewind release liner while the rear bottom rewind
tube is used to rewind finished product. To remove the
rewind tube, push the tube against the rewind brake and
remove the tube from the rewind support side.
60+ (-1)
CE
Page 19