GBC DELTA Operator's Manual page 10

Delta Laminator
•
To move the feeder head, turn the manual lever counter clockwise to loosen the clamp. Then
move the upper arm continuously along the guide bar. Do not get your fingers near the guide
bar. (The arm could hit the guide bar holder at the limit position).
•
Do not put any objects on the top surface of the feeder head.
•
Do not remove any covers. (The feeder head solid cover and protective rubber waved element).
•
The regulating knobs can be turned even if the machine is running. Only a trained operator can
adjust the machine.
•
The operator should wear tight fitting clothes to prevent being pulled into the machine by the
suction cups. Adjustments should be always done with only one hand.
© 2004 General Binding Corporation
Regulating
knobs
Operator Manual
11