Exhaust System - ABB Feather Duster V2 Product Manual

2.2.4 Exhaust system

General
The Feather Duster V2 works with an exhaust fan to suck and exhaust dust particles
from the feathers. The exhaust system of the Feather Duster V2 mainly includes
a suction slot with two flexible lips, an exhaust manifold, and an exhaust hose.
The 1,016 mm (diameter: 40") long suction slot is installed on the cover and spans
the full length of the feather shaft. The suction slot collects dusts and contaminants
from the feathers, and then the dusts and contaminants are exhausted through
the exhaust manifold and exhaust hose.
The exhaust air volume vary depending on the exhaust fan location, fan power and
ductwork arrangement. The Feather Duster V2 requires an air flow of at least 15
m
A pressure sensor connected to the ductwork ensures that the exhaust is running.
If no exhaust air flows, a fault will be generated.
Product manual - Feather Duster V2
3HAX010000210 Revision: A
3
/min at 1,500 Pa.
© Copyright 2018 ABB. All rights reserved.
2 About Feather Duster V2
2.2.4 Exhaust system
45